The principle and use precautions of horizontal glass washing machine
Horizontal glass washing machine is a special equipment for cleaning and drying glass surface before the deep processing of glass in mirror making, vacuum coating, tempering, hot bending, and insulating glass. Let me talk about the principle of horizontal glass washing machine and precautions for use.
The principle of horizontal glass washing machine
After the transducer converts high-frequency electrical energy into mechanical energy, it will generate high-frequency vibration with very small amplitude and spread to the solution in the cleaning tank. Under the action of the transducer, the interior of the cleaning fluid will continuously produce a large number of tiny The bubbles burst instantly, and the burst of each bubble will generate a shock wave of hundreds of degrees of high temperature and nearly a thousand atmospheres, so as to wash the workpiece clean.
can also be divided into two points simply:
First, after placing the flat glass on the horizontal glass washer, the glass is carried by the drive roller into the scrubbing room, and it is scrubbed by a brush sprayed with water, and then enters the flushing room, rinsed with pure water, and then enters the air drying room with a special The high-pressure fan completely peels off the water film to achieve a dry and clean cleaning effect.This type of glass washing machine is characterized by power saving but noisy.
The second is to blow only with breeze after passing through the scrubbing room and the flushing room, coupled with an electric drying system, to achieve a dry and clean cleaning effect, characterized by more power consumption and low noise.
Precautions for the use of horizontal glass washing machine
1. Be sure to turn on the blower first, and then turn on the heater. Turn off the heater first, then turn off the blower.
2. When the thickness of the glass plate changes, you must first adjust the height of the wind knife, otherwise it will cause damage.
3. Before stopping the transmission motor, be sure to lower the speed regulator to zero.
4. There is an emergency stop button on the console, which can be used in emergency situations.
5. The glass must be placed within the limit range of the feed section.
6. When adding tap water to the washing water tank, the water level cannot exceed 250MM. When the water level is lower than 200MM, add water in time.
Daily maintenance and maintenance of the machine is a very important thing. You should always observe the moving parts of the machine, the water system, the air system, and the electrical system. In case of emergency, stop and check immediately.