What are the application procedures that must be followed in a flat glass washer?
In the quest for perfect glass cleaning results, the flat glass washer becomes an indispensable assistant. This machine not only combines the functions of washing, squeezing, air drying and drying, but also ensures that each piece of glass is restored to its original lustre and transparency. In order to maximise its effectiveness and safeguard the operator, it is vital to follow the correct operating procedures. Below are the steps for operating a flat glass washer:
1. Preparation Stage
● Check the status of the equipment: Before using the flat glass washing machine, a detailed inspection should be carried out to confirm that all parts of the equipment are intact and function properly.
● Adjust the cleaning pressure: according to the thickness of the glass to adjust the copper joints copper screws on the spring pressure, to ensure that in the appropriate position.
● Prepare labour protection articles: before operation, wear gloves, earplugs and other labour protection articles to ensure the safety of the operator.
2.Setting Adjustment
● Adjust the pressure: Adjust the pressure of the copper joints copper screws on the spring according to the thickness of the glass to ensure that it is in the proper position.
● Power on: Turn on the power switch to make sure the voltage is between 380V~400V, and the power indicator light indicates that the power is on.
● Check the power connection: Make sure the power cord is not damaged and the plug is in good contact to avoid safety accidents caused by power problems.
3. Cleaning process
● Water pump start: Press the water pump button, open the water switch of the suction roller part, turn off the water switch after the suction cotton is fully wet.
● Brush cleaning: Press the brush button and switch on the fan to start the cleaning operation on the glass surface.
4.Drying process
● Transfer control: Press the transfer button, then turn on the oven switch and set the temperature at 110°C-120°C to dry the glass surface.
● Glass Placement: Place the glass to be cleaned on the transfer roller at the inlet, pass through the feeding section, cleaning section, water absorbing section, drying section, and arrive at the discharging section to receive the goods.
5. Safety Precautions
● Heating power-off: After heating power-off, let the fan (at this time the fan can't be cut off) send air for 3-5 minutes, so that the heating wire in the heating box can be cooled down, in order to protect the conveyor glue stick.
● Equipment maintenance: regular maintenance of the equipment to ensure the normal operation of the equipment and personnel safety, effectively reduce the failure rate and improve the efficiency of the equipment.
In addition, after understanding the above basic operation steps, there are some other information below:
● Ensure that the operator has received professional training and understands the basic functions and operating methods of the equipment.
● Before operating the equipment, check that the power supply is stable to avoid equipment damage or safety accidents caused by power problems.
● When cleaning and maintaining the equipment, follow the instructions provided by the equipment manufacturer and avoid using tools or cleaning agents that may damage the equipment.
In general, the operation of a flat glass washer involves a number of steps such as preparation, setup, cleaning, and drying treatment, each of which has its own specific operating requirements and precautions. Following the correct operating steps not only ensures the effectiveness of glass cleaning, but also ensures the safety of the operation process. Therefore, operators should fully understand and master these steps before operation, and at the same time, regular equipment maintenance and repair is also the key to ensure the normal operation of the equipment.